
A fence post repair in Shreveport is one of the most common fence problems we see, and it almost always comes down to water at the ground line. Posts set too shallow, or set without adequate concrete footing, shift and lean as clay soil moves with moisture. We dig out the old footing, reset the post to proper depth, and brace it solid again. The work is straightforward, the cost is reasonable, and it keeps a fence standing for years more. Whether your fence leans, your posts are rotting at the base, or you have a single post that has given way, we handle the repair on site with the same crew that installs new fences.
Why Leaning and Rotted Posts Are So Common in Shreveport
The Red River valley clay around Shreveport holds water, and water at the ground line is the enemy of fence posts. A post set only 24 or 30 inches deep will shift as soil expands and contracts with moisture cycles. Pressure-treated pine and cedar both resist rot, but neither one resists standing water at the base. Over time, the wood softens, the post loses bearing, and the whole fence line starts to lean. A single bad post can throw off the whole run, because the rails that tie the fence together transfer the load.
- Posts set in tamped soil alone will shift and loosen as ground moisture changes.
- Posts set in shallow concrete will heave and tilt if the footing does not reach below the active zone.
- Wood at or below the ground line absorbs moisture and begins to rot within three to five years without proper drainage.
- A leaning post puts extra stress on the rails and neighboring posts, spreading the damage across the fence.
Catching a leaning post early and resetting it deep in concrete saves you from having to replace the entire fence section later.
Key info: In Shreveport and Bossier City, we set fence posts a minimum of 36 inches deep in concrete, with the concrete sloped away from the post to shed water. This depth anchors the post below the active soil layer and keeps the wood out of the standing water zone. A properly set post will not lean.
For more details on how we handle fence problems, visit our fence repair page to see the full range of work we do.
How We Repair or Replace a Fence Post in Shreveport
The process depends on whether the post can be salvaged or must be replaced. If the post is still sound above the ground line and the damage is only at the base, we can often reset it without removing the fence. If the post is rotted through or too far gone, we replace it with a new pressure-treated post set the same way. Either way, we call 811 for a utility locate before we dig, remove the old footing, set the new post plumb, and backfill with concrete sloped away from the wood.
- We inspect the post to determine if it can be reset or must be replaced.
- We call 811 to locate underground utilities before digging the hole.
- We excavate the old footing and remove any rotted or unstable soil.
- We set the post to proper depth, brace it plumb, and pour concrete around it.
- We slope the concrete away from the post to drain water and protect the wood.
- We check the fence line with the neighboring posts to ensure everything is level and square.
The whole job usually takes one day, and the fence is ready to use once the concrete cures.
Real example: A homeowner in Greenwood had a wood privacy fence that was leaning away from the house. The middle post was set only 28 inches deep, and the concrete had cracked and settled. We reset that post 36 inches deep in new concrete, and the fence straightened up. The rails and pickets stayed intact, so we did not have to replace them. Total cost was about $485, and the fence has held solid for two years since.
If you have a damaged fence section or storm damage, our storm damage fence repair service covers emergency work and insurance documentation.
Repair Methods and When to Use Each One
| Approach | Description | Best for |
|---|---|---|
| Post Reset | Remove old footing, dig deeper, reset post in new concrete at correct depth. | Posts that are sound above ground but set too shallow or in failed concrete. |
| Post Replacement | Remove the damaged post, set a new pressure-treated post in concrete at full depth. | Posts rotted at the base or so far gone they cannot be straightened safely. |
| Bracing and Reinforcement | Install diagonal or cross bracing to stabilize a leaning post while concrete sets. | Posts that are leaning but structurally sound, to hold them plumb during the reset. |
| Concrete Repair | Chip out failed or sunken concrete, reset the post, and pour new concrete with proper slope. | Posts that have shifted because the original concrete cracked or settled unevenly. |
Each method is chosen based on what we find when we dig. A free on-site estimate tells you exactly which approach makes sense for your fence.
Fence Post Repair and Replacement Cost in Shreveport: What to Expect
A single post reset or replacement starts at around $410 and typically runs between $410 and $650, depending on the depth of the footing, the condition of the soil, and whether the post can be saved or needs to be replaced. If the post is rotted and the old concrete is deep or heavily compacted, the excavation takes longer and the cost moves up. If you have multiple posts that need work, we can usually offer a better per-post rate because we are already on site and have the equipment mobilized.
Several factors affect the final cost. The size and depth of the footing, the type of post material, access to the fence line, and whether the fence can stay in place during the repair all play a role. A post in the middle of a long run is easier to reset than one at a corner or gate opening, where the fence carries more stress. If the soil is clay-heavy or compacted, digging takes longer. A post that is rotted through costs more to replace than one that is simply leaning.
The best way to know your cost is to get a free estimate. We come out, dig a test hole if needed, assess the post and the footing, and give you a clear number. Visit our pricing page for more detail on all our services, or call (318) 666-4472 to schedule your free estimate.
Fence Post Repair and Replacement Near Me: What Shreveport Homeowners Should Know
When you are looking for fence post repair near you in Shreveport, Bossier City, or Greenwood, a few things matter. First, make sure the contractor you call is fully insured and can show you proof of coverage. Second, ask for references or examples of past work. Third, understand that many cities and some HOA communities have rules about fence height, setback, and material, so check with your local building department or HOA before you start work. Fourth, always call 811 before any digging, because underground utilities are a real risk and the call is free and required by law.
We are an AFA Member Installer with the American Fence Association, and we have been in business since 2015. We work from your existing survey or your identification of the fence line, and we install on the line you tell us is correct. If you have questions about permits, setbacks, or HOA rules, we can point you to the right place to ask, but the final answer always comes from your local building department or HOA.
The best next step is a free estimate. Call us at (318) 666-4472, or visit our contact page to request one. We respond within 24 hours and will give you a clear, honest answer about what your fence needs and what it will cost to fix it.
Fence Post Repair & Replacement in Shreveport: Pricing Guide
| Service | Price | Details |
|---|---|---|
| Single Post Reset | Starting at $410 | Reset an existing post to proper depth in new concrete, post stays in place, no removal needed |
| Single Post Replacement | Starting at $485 | Remove rotted or damaged post, install new pressure-treated post set 36 inches deep in concrete |
| Multiple Posts (3 or more) | Starting at $380 per post | Reset or replace three or more posts in the same fence run, reduced per-post rate due to mobilization |
| Complex or Damaged Footing | On estimate | Deep compacted concrete, poor soil conditions, or extensive rot require site inspection before pricing |
| Free Estimate | No charge | Response within 24 hours at (318) 666-4472, includes site assessment and written cost breakdown |
Indicative pricing, the exact cost depends on square footage, finish, and site access. Free personalized estimate within 24h at (318) 666-4472.